Two-notes VB-101 Bedienungsanleitung PDF herunterladen (Seite 23)

Connecting the TORPEDO VB-101

3 Combined setup

On stage or in the studio, you may need to feel the sound coming out of a cabinet. You can

simply connect a cabinet to the THRU output on the TORPEDO VB-101. You will be able to hear the

sound coming from the amp as usual, without any simulation or effect from the TORPEDO VB-101.

Once you plug a cabinet into the THRU output:

1. The ampliﬁer is directly connected to the cabinet,

2. The internal loadbox of the TORPEDO VB-101 is disconnected.

1 Speaker Input 2 Ampliﬁer’s Speaker Output 3 DAW or mixer

On this ﬁgure above, we have added an optional microphone to take the sound directly from the

cabinet. That way you can then get at the same time, in one take:

1. A classic track with a real cabinet and a microphone;

2. A simulated track using the TORPEDO VB-101 library of speakers and microphones;

3. A dry digital track with no simulation, for later re-miking (see next section).

This gives you a wide range of sonic possibilities, for you to make sure you get the tone you are

looking for!

When you plug a cabinet into the THRU output, the impedance of that

cabinet is the one that your ampliﬁer sees. In other words, with a 4-

Ohm cabinet, you need to connect to the 4-Ohm output of your am-

pliﬁer. In this conﬁguration, the loadbox inside the TORPEDO VB-101

will be disconnected. That way, you can override the "8 Ohms only"

limitation of the TORPEDO VB-101.

Two Notes Audio Engineering Torpedo VB-101 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 52 53

Keine Kommentare

Two-notes VB-101 Bedienungsanleitung Seite 23